Craftsman 917.272247 owner manual RexBolt, Engine

6.First connect RED battery cable to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely.

7.Connect BLACK grounding cable to negative (-) battery terminal with remaining hex bolt and keps nut. Tighten securely

8.Close terminal access doors.

9.Close hood.

	Keps,.Nut _
Access	.... ..'	. _	L:_	,Y
Door_:		!_	_f	_\
Terrnina_	_.__<:_?=_wy			RexBolt
				--Positive (Red)
Guard ---;_---_E_J_			_--
	I I	_	_	Cable
	I	_		Negative
	"_	V		(Black) Cable

TO REPLACE HEADLIGHT LAMP

_CAUTION: When lit, the halogen lamps

get extremely hot. Hold lamp assembly by the holder and do not touch the bulb.

1.Raise hood.

2.Disconnect harness from lamp assembly.

3.Rotate counterclockwise and pull lamp assembly out of the hole in the backside of the grill.

4.Insert new lamp assembly and rotate clockwise to lock.

5.Reconnect harness to lamp assembly.

6.Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring

diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type

plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL AS-

SEMBLY

1.Raise hood.

2.Unsnap headlight wire connector.

3.Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

4.When replacing hood, be sure to

reconnect the headlight wire connec- tor.

_Hood

Headlight Wire

Connector

®

ENGINE

Maintenance, repair, or replacement of the emission control devices and sys- tems, which are being done at the customers expense, may be performed by any non-road engine repair establish- ment or individual. Warranty repairs must

be performed by an authorized engine manufacturer's service outlet.

TO ADJUST THRO'I-rLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as de- scribed below before loosening cable. If adjustment is necessary, proceed as follows:

1.With engine not running, move throttle control lever to fast position.

2.Check that speed control lever is against stop screw. If it is not, loosen casing clamp screw and pull throttle cable until lever is against screw. Tighten clamp screw securely.

Idle

Adjusting

Needle

	Throttle
	Control
	Cable
	Control
Stop	Cable
Clamp	Screw

26