Your new tractor has been assembled at the factory. Review the video cassette before you begin.
When right or left hand is mentioned in this manual, it means, from your point of view, when you are in the operating posi- tion (seated behind the steering wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
1.Cut, from top to bottom, along lines on all four corners of carton, and lay panels flat.
2.Remove packing materials.
3.Remove protective materials from tractor hood and grill.
IMPORTANT: Check for and remove any
staples in skid that may puncture tires where tractor is to roll off skid.
CHECK BA'n'ERY
1.Lift hood to raised position.
NOTE: If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at
/"°" ,,.."'" | Label |
ADJUST SEAT
1.Raise seat and loosen adjustment knob.
2.Lower seat into operating position and sit in seat.
3.Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.
4.Get off seat without moving its adjusted position.
5.Raise seat and tighten adjustment knob securely.
Adiostment
Knob
NOTE: You may now roll or drive your
tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.
TO ROLLTRACTOR OFF SKID (See
Operation section for location and function of controls)
1.Press lift Fever plunger and raise attachment lift lever to its highest position.
2.Release parking brake by depressing brake pedal.
3.Place freewheel control in "transmis- sion disengaged" position (See "TO TRANSPORT' in the Operation
section of this manual).
4. Roll tractor forward off skid.
TO DRIVE TRACTOR OFF SKID (See
Operation section for location and
function of controls)
A WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a
other people and objects.
1.Be sure all the above assembly steps have been completed.
2.Check engine oil level and fill fuel tank with gasoline.
3.Place freewheel control in "transmis- sion engaged" position. (See "TO TRANSPORT' in the Operation section of this manual).
4.Sit on seat in operating position, depress brake pedal and set the parking brake.
5.Press lift lever plunger and raise attachment lift lever to its highest position.
7
