Optima Batteries P90 manual 167, Troubleshooting, Electronically Controlled Cameras

Troubleshooting

Problem	Cause/Solution	A
Date imprint not	Date has not been set.	20, 138
available.
	Dates cannot be imprinted in the following situations.
Date not	• When Museum, or Panorama assist is selected in scene	45, 47
	mode.
appearing on
	• When Continuous or BSS is selected for Continuous	118
pictures even
	• When any setting other than Off is selected for Auto	121
when Date
	bracketing
imprint is
	• When y(blink proof) is selected	55
enabled.
	• When sport continuous mode is selected	56
	• Movies	81
Camera settings	Backup battery is exhausted; all settings were restored to	139
reset.	their default values.
	• Reset file numbering cannot be applied when the	154, 156
	folder number reaches 999 and there are images in the
Reset file	folder. Change the memory card, or format the internal
	memory/memory card.
numbering cannot
	• Reset file numbering cannot be done if scene mode is	154, 156
be done.	set to Panorama assist or Voice recording, and if
	Continuous is set to Intvl timer shooting when A, B,
	C, D, Eor Fshooting modes are used.
	Battery temperature is high. Turn off camera, and allow
Monitor turns off,	battery to cool down before resuming use. After the lamp
and the power-on	blinks for three minutes, the camera will turn off	19
lamp blinks rapidly.	automatically, but you can also press the power switch to
	turn it off manually.

Electronically Controlled Cameras

In extremely rare instances, unusual characters may appear in the monitor and the camera may stop functioning. In most cases, this phenomenon is caused by a strong external static charge. Turn the camera off, remove and replace the battery, then turn the camera on again. In the event of continued malfunction, contact your retailer or Nikon-authorized service representative. Note that disconnecting the power source as described above

may result in the loss of any data not recorded to internal memory or the memory card at

the time the problem occurred. Data already recorded will not be affected.Technical Notes

167