Craftsman 917.273322 To Replaceheadlightbulb, Interlocksandrelays, To Replacefuse, Engine

TO REPLACEHEADLIGHTBULB

\

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

Headlight Wire

Connector

INTERLOCKSANDRELAYS

Loose or damaged wiring may cause

your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACEFUSE

Replace with 30 amp automotive-type

plug-in fuse. The fuse holder is located behind the dash.

TO ADJUST ATTACHMENT LIFT SPRING

•While holding spring bushing with wrench, loosen jam nut.

•Turn adjustment bolt clockwise to extend spring and reduce lift effort for heavier attachments.

•Turn adjustment bolt counterclockwise for lighter attachments.

•Retighten jam nut against spring bushing.

IMPORTANT: Do not adjust for maxi- mum spring tension when using _ight attachments such as a mower. Adjust lift lever spring to aid in lifting attachment. Do not overpower spring. When remov- ing attachment, always adjust spring tension to its lowest position.

(/__J Adjustment Bolt

pring Bushing

ENGINE

Maintenance, repair, or replacement of the emission control devices and

systems, which are being done at the customers expense, may be performed by any non-road engine repair establish ment or individual. Warranty repairs mus be performed by an authorized engine manufacturer's service outlet.

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not b_ necessary. Check adjustment as de- scribed below before loosening cable. If adjustment is necessary, proceed as follows:

•With engine not running, move throttl_ control lever to fast position.

•Check that speed control lever is against stop screw. If it is not, loosen casing clamp screw and pull throttle cable until lever is against screw. Tighten clamp screw securely.

Idle Fuel Adjusting Idle speed Adjusting Needle

	_ntLift	Throtth
_,	:, _, Spring	Centre
		Cable

Jam Nut

TO REMOVE HOODAND GRILL

ASSEMBLY

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

Stop
Screw	Screw
Clamp
29	Choke Control Cabh