L.H. Secondary
Mandrel Idler Arm Idler Pulley
Mower Blade
(Secondary) Drive Belt
B.H.
Mandrel
TO ADJUST ATTACHMENT CLUTCH
The electric clutch should provide years of service. The clutch has a
that stops the pulley within 5 seconds. Eventually, the internal brake will wear which may cause the mower blades to not engage, or, to not stop as required.
Adjustments should be made by a Sears or other qualified service center.
1.Make sure attachment clutch and ignition switches are in =OFF" position.
2.Adjust the three nylon Iocknuts until
space between clutch plate and rotor measures .012" at all three slot
locations cut in the side of brake plate. NOTE: After installing a new electric clutch, run tractor at full throttle and
engage and disengage electric clutch 10 cycles to wear in clutch plate.
.012"
Slot
ake
Nylon Locknut (3) | Plate |
TO ADJUST BRAKE
Your tractor is equipped with an adjustable brake system which is mounted on the side of the transaxle.
If tractor requires more than six (6) feet stopping distance at high speed in highest gear on a level dry concrete or paved surface, then brake must be adjusted.
1.Depress clutch/brake pedal and engage parking brake.
Secondary
Arm
Center
Mand_l
2.Measure distance between brake
operating arm and nut "A" on brake rod.
3.If distance is other than
4.Road test tractor for proper stopping distance as stated above. Readjust if necessary. If stopping distance is still
greater than six (6) feet in highest gear, further maintenance is neces-
sary. Contact a Sears or other qualified service center.
With parking brake "Engaged"
Nut =A"
Nut
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage parking brake. For ease of service there
is a belt installation guide decal on bottom of left footrest.
1.Remove mower (See "TO REMOVE MOWER" in this section of this
manual.)
BELT REMOVAL -
2.Create slack in belt by removing retainer spring from drive belt tension handle.
24
