![](/images/new-backgrounds/1098193/9819321x1.webp)
| the eyes, which can result in severe eye damage. Always wear | ||||||
| safety | glasses | or eye shields | while operating | your | tractor | or |
I_ | performing any adjustments or repairs. We recommend standard | ||||||
he operation | of any tractor can result in foreign | objects | thrown into | ||||
_ | safety | glasses | or a wide vision | safety mask | worn | over spectacles. |
HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE
Your tractor is equipped with an operator presence sensing switch. When engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine.
1.Depress clutch/brake pedal all the way down and hold.
2.Pull parking brake lever up and release pressure from clutch/brake pedal. Pedal should remain in brake
position. Make sure parking brake will hold tractor secure.
Choke | Attachment | |
| engage" | Clutch Switch Pull |
Throttle
Control,
_otion
PedalControl
Lever
Parking Brake
Knob "Disengaged" "Engaged"
Brake Pedal Position Position
=Ddve" Position
STOPPING
MOWER BLADES -
•To stop mower blades, push attach- ment clutch switch in to disengaged position.
GROUND DRIVE -
• To stop ground drive, depress brake
pedal all the way down.
IMPORTANT: The motion control lever
returns to neutral (N) position when the brake pedal is fully depressed.
ENGINE -
•Move throttle control to slow position. NOTE: Failure to move throttle control to
slow position to allow engine to idle
before stopping may cause engine to "backfire".
•Turn ignition key to "STOP" position and remove key. Always remove key when leaving tractor to prevent unauthorized use.
•Never use choke to stop engine.
IMPORTANT: Leaving the ignition switch in any position other than "STOP" will
cause the battery to discharge and go dead.
NOTE: Under certain conditions when tractor is standing idle with the engine running, hot engine exhaust gases may cause "browning" of grass. To eliminate this possibility, always stop engine when stopping tractor on grass areas.
_I, CAUTION= Always stop tractor completely, as described above, before
leaving the operator's position.
TO USE THROTTLE CONTROL Always operate engine at full throttle.
•Operating engine at less than full
throttle reduces the battery charging rate.
•Full throttle offers the best mower performance.
TO USE CHOKE CONTROL
Use choke control whenever you are starting a cold engine. Do not use to start a warm engine.
•To engage choke control, pull knob out.
Slowly push knob in to disengage.
TO MOVE | FORWARD AND |
BACKWARD |
|
_CAUTION: | Do not attempt to operate |
motion control lever when the parking brake is set or when the brake pedal is depressed. Doing so may result in misadjustment to the drive control system. The direction and speed of movement is controlled by the motion control lever.
1.Start tractor with motion control lever in neutral (N) position.
2.Release parking brake.
3.Slowly move motion control lever to desired position.
TO ADJUST MOWER CUTTING HEIGHT
The cutting height is controlled by turning the height adjustment knob in desired direction.
• | Turn | knob clockwise (_) | to raise | |
| cutting | height. |
| |
• | Turn | knob | counterclockwise | (1_'_)to |
11 | lower | cutting | height. |
|
|
|
|
|