
4.FirstconnectREDbatterycable(B)to
positive(+)batteryterminalwithhex
boltandkepsnutasshownTighten.
securelySlideterminalcover(C)over.
terminal.
5.ConnectBLACKgroundingcableto
6.Closehood.
iNegative
(Black) Cable
Positive (Red) Cable
TO REPLACE HEADLIGHT BULB
1.Raise hood.
2.Remove bulb holder from the hole in the backside of the grill.
3.Replace bulb in holder and install bulb holder securely back into the hole in the backside of the grill.
4.Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or prevent it from starting.
•Check wiring. See electrical wiring diagram in the Repair Parts manual.
TO REPLACE FUSE
Replace with 20 amp
TO REMOVE HOOD & GRILLASSEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
4.When replacing hood, be sure to re- connect the headlight wire connector.
Headlight Wire
Connector
ENGINE
TO ADJUST THROTTLE CONTROL
The throttle control has been preset at the factory and adjustment should not be necessary Check adjustment as described below before loosening cable. If adjustment is necessary, see engine manual.
TO ADJUST CHOKE CONTROL
The choke control has been preset at the factory and adjustment should not be neces- sary. If adjustment is necessary, see engine manual.
TO ADJUST CARBURETOR
Your carburetor has been preset atthe factory and adjustment should not be necessary. However, minor adjustment may be required to compensate for differences in fuel, tem- perature, altitude or load. If the engine does need adjustment, see engine manual.
TRANSMISSION REMOVAL/REPLACE= MENT
Should your transmission require removal for service or replacement, it should be purged after reinstallation and before op- erating the tractor. See "PURGE TRANS-
MISSION" in the Operation section of this manual.
26