TIRE CARE
_.CAUTION: When mouhting tires, un- less beads are seated, overinflation can cause an explosion.
•Maintain 20 pounds of air pressure. If tire pressures are not equal, tiller will pull to one side.
•Keep tires free of gasoline or oil which can damage rubber.
TO REMOVE WHEEL
•Place blocks under transmission to keep tiller from tipping.
•Remove hairpin clip and clevis pin from wheel.
•Remove wheel and tire.
•Repair tire and reassemble.
is Pin
".1
HairpinC/lip
TO REMOVE BELT GUARD
NOTE: For ease of removal, remove hair-
pin clip and clevis pin from left wheel. Pull wheel out from tiller about 1 inch.
•Remove two (2) screws, one (1) nut and washer from side of belt guard.
•Pull belt guard out and away from unit.
•Replace belt guard by reversing above procedure.
_lt | Gu_ |
|
/ | _Hex | Nut |
I |
| and |
|
| W her |
X_"_ | 3\ | (Located |
_ _ | ||
screws
Hairpin Clip and Clevis Pin
TO REPLACE GROUND DRIVE BELT
•Remove belt guard as described in =TO
REMOVE BELT GUARD",
•Remove old belt by slipping off engine pulley first then remove from transmis-
sion pulley.
•Place new belt in groove of transmis- sion pulley and into engine pulley. BELT MUST BE IN GROOVE ON TOP OF
IDLER PULLEY. NOTE POSITION OF BELT TO GUIDES.
•Check belt adjustment as described below.
•Replace belt guard.
•Reposition wheel and replace clevis pin and hairpin clip.
GROUND DRIVE BELT ADJUST- MENT
For proper belt tension, the extension spring should have about 5/8 inch stretch when drive control bar is in =ENGAGED" position. This tension can be attained as
follows;
•Loosen cable clip screw securing the drive control cable.
•Slide cable forward for less tension and rearward for more tension until about 5/8 inch stretch is obtained while the drive control bar is engaged.
•Tighten cable clip screw securely.
16
