Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use the correct tools
as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
FRONT
A socket wrench set will make assembly easier. Standard wrench sizes are listed.
(1) | Utility knife |
|
|
(1) | Wire cutter |
|
|
(t) Tire pressure gauge | LEFT | RIGHT | |
(1)Screwdriver
(1)Pair of pliers
(1)9/16" wrench
OPERATOR'S POSITION
When right or left hand is mentioned in
this manual, it means whenyou are in the operating position (standing behind
tiller handles).
OPERATOR'S
POSITION
CONTENTSOF HARDWARE PACK
/IIIIIII/Y @
(2) Handle Locks | (1) Center Locknut | |
(1) Carriage Bolt | ||
, |
(1) Cable Clip | |
|
121Ha,_,nc,,pst L ) )
(1) Pivot Bolt
°1 | _J"3/32x 1 x 11 Ga. ' |
O | |
Extra Shear Pins & Clips | (1) Handle Lock Lever |
|
I
5
