The operation of any lawn mower can result in foreign

objectsthrowninto theeyes, which can result in severe

eye damage, Always wear safety glasses or eye shields while oper- ating your lawn mower or performing any adjustmentsor repairs, We recommend a standardsafetyglassesorwidevisionsafety maskworn over spectacles,

HOW TO USE YOUR LAWN MOWER

ENGINE SPEED

Engine speed was set at the factory for

optimum performance, It is not adjustable,

ENGINE ZONE CONTROL

_kCAUTION: Federal regulations require an engine control to be installed on this lawn mower in order to minimize the

risk of blade contact injury, Do not under

any circumstances attempt to defeat the function of the operator control, The blade turns when the engine is running,

Your lawn mower is equipped with an operator presence control bar which

requires the operator to be positioned behind the lawn mower handle to start

and operate the lawn mower,

DRIVE CONTROL

Self-propelling is controlled by hold- ing the operator presence control bar down to the handle and pulling the drive control lever rearward to the handle.

The farther toward the handle the lever is pulled, the faster the unit will travel.

Forward motion will stop when either the operator presence control bar or drive control lever are released. To stop forward motion without stopping engine,

release only the drive control lever. Hold operator presence control bar down against handle to continue mowing without self-propelling.

NOTE: If after releasing the drive control the mower will not roll backwards, push the mower forward slightly to disengage drive wheels.

Operator presence control bar Drive control lever

TO

ENGAGEDRIVE

DRIVECONTROL

CONTROLDISENGAGED

DRIVE CONTROL ADJUSTMENT

Over time, the drive control system may become "loose", resulting in decreased

speed, There is a turnbuckle on the

underside of the drive control housing to increase tension on the drive cable, Pro-

ceed as follows:

1, Turn unit off and disconnect spark plug

wire from spark plug,

2, Turn nut on underside of drive control to increase drive speed,

3, Operate mower to test drive speed, Readjust as required,

4, If condition fails to improve after the above steps (forward speed remains the same), your drive belt is worn and should be replaced,

Adjustment turnbuckle

TO ADJUST CUTTING HEIGHT

Both front wheels are adjusted by a single lever on the left front wheel, Likewise, both rear wheels are adjusted by a single lever on the left rear wheel,

Pull adjuster lever toward wheel, To raise mower, move lever forward to desired position, To lower mower, move the lever backward to desired position,

Be sure to adjust both front and rear wheels

to the same height,

Height

uster lever

TO LOWER MOWER

 

 

LEVER BACKWARD

 

 

LEVER FORWARD

TO RAISE MOWER

TO CONVERT MOWER

Your lawn mower was shipped ready to be used as a mulcher, To convert to rear

bagging or side discharging:

REAR BAGGING

Remove knob securing mulcher door to lawn mower housing.

Open mulcher door and insert tabs of discharge chute into hinge bracket opening and position rear of chute over threaded stud.

Page 9
Image 9
Craftsman 917.37712 manual Engine Speed, Engine Zone Control, Drive Control, To Adjust Cutting Height, Rear Bagging