Craftsman 917.38836 owner manual To Assemble Grass Catcher, Carburetor, Engine Speed

TO ASSEMBLE GRASS CATCHER

•Put grass catcher frame into grass bag

with dgid part of bag on the bottom.

Make sure the frame handle is outside of the bag top.

•Slip vinyl bindings over frame.

NOTE: If vinyl bindings are too stiff, hold them in warm water for a few minutes. If

bag gets wet, let it dry before using. ACAUTION: Do not run your lawn mower without clipping deflector or approved grass catcher in place. Never attempt to

operate the lawn mower with the rear door removed or propped open.

Catcher .--_

handle _ _/'_ \ _ ./k\\

opening

ENGINE

CARBURETOR

Your carburetorhas a non-adjustsblefixed main jet for mixturecontrol. Ifyour engine does not operate properlydue to suspected carburetorproblems,take your lawn mowerto an authorizedservicecenterfor repairor adjustment.

IMPORTANT: Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous, if you think the engine-governedhigh speed needs adjusting, contact your nearest authorized service center, which has proper equipment and experience to make any necessary adjustments.

ENGINE SPEED

Your enginespeed has been factoryset Do not attemptto increaseenginespeed or it

may resultin personal injury. If you believe that the engineis running too fast or too slow,

take your lawn mowerto an authonzed service center for repairand adjustment.

14