TROUBLESHOOTING |
| CHART |
PROBLEM |
| CAUSE |
Poor cut- uneven | 1. | Worn, bent or loose blade. |
| 2. | Wheel heights uneven. |
| 3. | Buildupof grass, leaves |
|
| and trash under mower. |
Excessive | 1. | Worn, bent or loose blade. |
vibration |
|
|
| 2. | Bent engine crankshaft. |
CORRECTION
1.Replace blade. Tighten blade bolt.
2.Set all wheeis at same height
3.Clean underside of mower hou_ng.
1.Replace blade. TKjhten blade bolt.
2.Contact an authorized service center.
Starter rope hard to pull
1.Engine flywheel brake is on when control bar is released
2.Bent engine cranksh_t.
3.Blade adapter broken.
4.Blade dragging in grass.
1.Depress contro! bar to upper handle before pulling starter rope.
2.Contact an authorized service center.
3, Replace blade adapter.
4.Move lawn mower to cut grass or to hard surface to start engine
Grass catcher
not filling (if so
equipped)
Hard to push
1. | Cutting height too low. | 1. | Raise | cutting height. | |
2. | Lift on blade | wom off. | 2. | Replace blade. | |
3. | Catcher not venting _r. | 3. | Clean | grass catcher. | |
1. " Grass is too high or wheel | I. | Raise | cutting height. | ||
| h_ight is too low. |
| Raise rear of lawn mower | ||
• I 2. | Rear of lawn mower | . | |||
| housing or blade dragging |
| housingone (1) setting | ||
| in grass. |
|
| higher. | |
3. | Grass _r | too full. | 3. | Emptygrass catcher. | |
4.Handlet_ght pes_onnot 4. Adjusthendle heightto
rightforyou.suit.
17
