Installing Handles, Wheels, and Molded Foot Bumpers
The wheels and handle do not provide adequate
clearance, stability or support for pulling the unit up and down stairs or steps. The unit must be lifted, or pushed up a ramp.
1.Submerge handle grip into warm soapy water to make installation easier. Remove handle grip from soapy water and slide onto handle.
2.Slide handle through holes in compressor saddle onto tabs. Secure with screws, one on each side.
Compressor Saddle
Handle | Screw | Tab |
It will be necessary to brace or support one
side of the outfit when installing the wheels because the compressor will have a ten- dency to tip over.
3.Install one shoulder bolt and one nut for each wheel. Tighten securely. The outfit will sit level
if the wheels are properly installed.
Wheel |
Nut |
Shoulder Bolt |
4.Clean and dry underside of air tank leg opposite wheels. Remove the protective strip from the adhesive backed molded foot bumpers. Attach the foot bumpers to the bottom of leg on each end. Press firmly into place.
Molded Foot Bumpers
D21996 |
