Kenwood TH-D7E, TH-D7A Installing the Antenna, Installing the Hand STRAP/ Belt Hook, Batteries

The following table shows the approximate battery life (hours) relative to the transmit output power.

Batteries		VHF Band				UHF Band
	H		L	EL	H		L	EL
PB-39 NiCd	3		6	9	3		6	9
PB-38 NiCd	4.5		7	10	4		7	10

Note:

◆Charge the NiCd battery pack within an ambient temperature of between 5°C and 40°C (41°F and 104°F). Charging outside this range may not fully charge the pack.

◆Repeatedly recharging a fully charged NiCd battery pack, or almost fully charged pack, shortens its operating time. To resolve this problem, use the pack until it is completely discharged. Then recharge the pack to full capacity.

◆If the operating time of a fully charged NiCd battery pack is much shorter than before, the battery life is over. Replace the pack.

INSTALLING THE ANTENNA

Hold the provided antenna at its base, and screw the antenna into the connector on the top panel of the transceiver until it is snug.

INSTALLING THE HAND STRAP/ BELT HOOK

If desired, attach the provided hand strap and/ or belt hook.

Belt hook

Hand strap

To remove the belt hook, pull the belt hook downward while pushing its tabs from both sides.

To lock the cable of an optional speaker microphone, first position the cable over the left groove on the transceiver. Then install the belt hook. Last, position the cable over the right groove.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

3