1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
38
■Using Program Scan
1Select the appropriate band.
2Press [VFO] .
3Select a frequency equal to or between the
programmed scan limits.
4Press [VFO] (1 s).
• Scan starts at the frequency currently displayed.
• The 1 MHz decimal blinks while scanning is in
progress.
• To reverse scan direction, press [UP] (upward scan)
or [DWN] (downward scan).
5To quit Program Scan, press [ESC].
Note:
◆
If the step size of the current VFO frequency differs from that of
the programmed frequencies, you cannot use Program Scan.
◆
If the step size differs between the lower limit and the upper limit,
you cannot use Program Scan.
◆
If the current VFO frequency is within more than one
programmed scan range, the range stored in the smallest
channel number is used.
CALL/VFO SCAN (TH-D7A ONLY)Use Call/VFO Scan to monitor both the Call channel and
the current VFO frequency on the selected band.
1Select the desired band.
2Press [VFO].
3Select the desired frequency.
4Press [CALL] (1 s) to start Call/VFO Scan.
• The 1 MHz decimal blinks while scanning is in progress.
5To quit Call/VFO Scan, press [ESC].
CALL/MEMORY SCAN (TH-D7A ONLY)Use Call/Memory Scan to monitor both the Call channel
and the desired memory channel.
1Recall the desired memory channel.
2Press [CALL] (1 s) to start Call/Memory Scan.
• The 1 MHz decimal blinks while scanning is in progress.
• The Call channel on the same band as of the selected
memory channel is used for Scan.
3To quit Call/Memory Scan, press [ESC].
Note: The memory channel last used is scanned even if it has been
locked out.
TH-D7 E 33 Scan 98.12.4, 0:11 PM38