Kenwood TH-D7A Dwait, Echo ON/ OFF, Firmrnr FIR OFF ON/ OFF, Flow ON/ OFF, Frack, Gbaud, Gpssend

Command Name	Short	Default	Parameter	Description
				Causes the TNC to display the current status of all the
				commands. You can also specify a class identifier A, C, H, I,
				L, M, or T to display the status of only the desired command
				class. Enter a space between the command name and a
				class identifier; ex. DISPLAY H.
DISPLAY	DISP	—	—	A (ASYNC): RS-232C port parameters
				C (CHAR): Special TNC characters
				H (HEALTH): Counter parameters
				I (ID): ID parameters
				L (LINK): TNC-to-TNC link status
				M (MONITOR): Monitor parameters
				T (TIMING): Timing parameters
DWAIT	DW	30	0 ~ 250	Specifies the interval from no carrier detection until execution
				of transmission. The unit of the parameter is 10 milliseconds.
ECHO	E	ON	ON/ OFF	When ON, causes the TNC to echo received characters to the
				computer.
				The other station sends a notice (packet) to you if it is not
FIRMRNR	FIR	OFF	ON/ OFF	ready to receive data. When ON, receiving such a notice
				causes the TNC to suspend transmission until it receives a
				“ready” notice.
FLOW	F	ON	ON/ OFF	When ON, starting key entry causes the computer to stop
				displaying received packets.
FRACK	FR	3	0 ~ 250	Specifies the interval from one transmission until retry of
				transmission. The unit of the parameter is 1 second.
GBAUD	GB	4800	4800/ 9600	Selects 4800 or 9600 bps as the transfer rate between the
				TNC and the GPS receiver.
			0 ~ 159	Specifies the content of data to be output to the GPS receiver;
GPSSEND	GPSS	—		this data is used to program the default settings on the
			characters
				receiver. The output data is not stored in memory.
GPSTEXT	GPST	$PNTS	0 ~ 6	Specifies the type of a message to be determined by LTEXT.
			characters

100