7.If you are applying a chemical or cleaning solution, See How To

Apply Chemicals and Cleaning Solvents in Operation section of this manual.

8.Turn water source on.

NOTE: Make sure water supply is turned on.

9.Move the choke control lever to

the CHOKE ON position and

the throttle control to the FAST

position. NOTE: No choke is needed to start a warm engine.

Throttle

Control

Choke

Control

10.Pull starter grip slowly until you feel resistance, then pull briskly. Return starter grip gently. Pull rope with a rapid full arm stroke. Let rope rewind slowly. Repeat if necessary.

If the engine does not start after two

pulls, pull the trigger to relieve the pressure.

11.If the choke was used to start the engine, move the choke lever to the OFF position.

12.Depress trigger on gun to start water flow. Release trigger to stop water flow.

13.Adjust nozzle spray for the task being performed. See How To Use Spray Wand instructions in this section.

DO NOT let hoses come in contact

with very hot engine muffler during or immediately after use of your pressure washer.

MAINTENANCE

When performing maintenance, you may be exposed to hot surfaces, water pressure, or moving parts that can cause

serious injury or death!

Before performing any maintenance or repair, disconnect spark plug wire, let engine cool and release all water pressure. The engine contains flammable fuel. DO NOT smoke or work near open flames while performing maintenance.

To ensure efficient operation and longer life of your pressure washer, a routine maintenance schedule should be prepared and followed. If the pressure washer is used in unusual conditions, such as high-temperatures or dusty conditions, more frequent maintenance checks will be required.

D30339

14- ENG

D30339

 

Page 14
Image 14
Craftsman 919.672180, D30339 owner manual Maintenance