Craftsman 919.76235 Service Air Cleaner, Pre-Cleaner, Carburetor, Multi-Reg Wand/Lance

Service Air Cleaner

Your engine is equipped with an oval dual element.

•To service element: loosen screws and lift cover. Then carefully remove pre-cleanerand cartridge assembly.

•After servicing pre-cleaner and cartridge, place pre-cleaner on cartridge.

•Install air cleaner assembly in base. Then install

cover on air cleaner and tighten screws securely to base.

sc-s Z

PRE-CLEANER _ CARTRIDGE

Pre-Cleaner

To service pre-cleaner, wash in liquid detergent and water. Allow to dry thoroughly before using. Do not oil pre-cleaner. Replace if very dirty or damaged.

NOTE: Do not use petroleum solvents, e.g., kerosene, which will cause the cartridge to deteriorate. Do not use pressurized air to clean cartridge. Pressurized air can

damage the cartridge.

Keep engine and parts cleanl

Carburetor

The carburetor of your high pressure washer is pre-setat the factory. The carburetor should not be tampered with. If your pressure washer is used at an altitude in excess of 5000 feet consult with your nearest Sears Service Center regarding high altitude set changes.

_, CAUTION: Engine speed was properly adjusted at the factory and should require no additional adjustment. Do not attempt to change engine speed. If you believe the engine is running too fast or too slow, take your pressure washer to a Sears Authorized Service Center for repair and adjustment.

increase the risk of personal injury or damage to

I A WARNING:equipment, High engine speeds are dangerous and

•Do not clean engine with a forceful spray of

water because water could contaminate fuel system.

With a brush or cloth, clean finger guard after every use to prevent engine damage caused by overheating.

CLEAN

CLEAN_

•Before running engine, clean muffler area.

CLEAN

Clean and Replace Spark Plug

Change the spark plug every 100 hours of operation or once each year, whichever comes first. This will help

your engine to start easier and run better.

.030" (0,76 MM)

WIRE GAGE

RESISTOR

I

•, CAUTION: Low engine speeds impose a heavy I load on the engine and when sufficient engine I power is not available could shorten engine life.

Nozzle cleaning:

If the nozzle becomes clogged with foreign materials, such as dirt, excessive pressure may develop. If the nozzle becomes partially clogged or restricted, the pump pressure will pulsate. Clean the nozzle immedi-

ately using the nozzle kit supplied and the following instructions:

Multi-Reg Wand/Lance:

1.Shut off the pressure washer and turn off the water supply.

2.Disconnect spark plug wire.

13