Tools Required for AssemblyAdjustablewrench
Allenwrench 5ram (included)
Remove Pressure Washer from Carton
• Open boxfrom the top. Locate and remove from
box, the parts box, which includes gun, handle,
wand,oil, knobs and J bolts. Next removethe parts
bag and the handle.
• Cut carton along dotted lines.
•Remove all carton inserts.
•Rollunit through opening inCarton,
NOTE: The hose is located at the bottom of the box,
Preparing the Pressure Washer for First Use
Note: Included with your pressure washer is a
videocassette tape on how to prepare your unit
foroperation. It is recommended you view this
tape before performing the next steps,
1. •Inserthandle onto frame.
•SlideJ bolts into frame.
•Tighten knobs turning inclockwise direction.
!ir lghten knob in clockwise
ctinn to threaded end of J bob+)
(inzertJ bolt Itere, Th,,,_zdedend
_9oes inbOt_m hole)
2. =Usingan adjustable wrench, remove nut from bolt
that attaches board to frame. Remove wood plank
from the frame ofthe unit. Discard bolt and board.
3. • Mount the rubber isolator to the frame. To mount
isolatorplace threaded end of bolt through the
washer. Next with washer on boIt place threaded
end of bolt throughthe larger hole in bottom of the
rubberisolator. Place threaded portion of bolt
through the same hole location the wood plank
was mounted to on the pressure washer. Next
place the tee nut over the threaded portion of the
bolt and use the allen wrench provided to tighten
isolatorto the frame.
PRESSURE TEE NUT
WASHe. I
L J
-- ISOLATOR
4. • Connect wand extension to gun. To tighten, turn
knob in clockwise direction. Hand tighten.
5. =Remove tie wrap off of high pressure hose.
Unwind high pressure hose and attach the
threaded end to the gun.
6. • Connect high pressure hoseto outlet on pressure
washer and hand tighten firmly. Connect
chemical pickup hose to hose barb on pump.
CHEMICAL-'--'---_k-_ II HOSE
NOTE: Always keep hose away from engine muffler.
6