CHUCKREMOVAL
See Figures 11, 12, and 13.
The chuck must be removed in order to use some accessories. To remove:
•Lock the switch trigger by placing the direction of rotation selector in center position.
•Insert a 5/16 inch or larger allen wrench (hex key wrench) into the chuck of your drill and tighten the chuck jaws securely.
•Tap the allen wrench sharply with a mallet in a clockwise direction. See Figure 11. This will loosen the screw in the chuck for easy removal.
MALLET
KEYLESS CHUCK
CHUCK JAW.€
Insert allen wrench in chuck and tighten chuck jaws securely, Tap sharply with a mallet in a counterclockwise direction. This will loosen chuck on the spindle, it can now be unscrewed by hand. See Figure 13.
Fig. 13
TO RETIGHTEN A LOOSE CHUCK
ALLEN
WRENCH
Fig. 11
Open chuck jaws and remove allen wrench. Remove the chuck screw by turning it in a clock- wise direction. See Figure 12. Note: The screw has left hand threads.
Fig. 12
The chuck may become loose on spindle and develop a wobble. Also, the chuck screw may become loose causing the chuck jaws to bind and prevent them from closing. To tighten, follow these steps:
•Lock the switch trigger by placing the direction of rotation selector in center position.
•Insert allen wrench into chuck and tighten chuck jaws securely. Tap allen wrench sharply with a mallet in a clockwise direction. This will tighten chuck on the spindle.
Open the chuck jaws and remove allen wrench.
Tighten the chuck screw. Note: The chuck screw has left hand threads.
12
