,_, WARNING: Always wear safety goggles or safety glasses with side shields when operating

tools. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury.

_, WARNING: Do not allow familiarity with your drill-driver to make you careless. Remember that a careless fraction of a second is sufficient to

inflict severe injury.

CHARGING BAI-FERY PACK

The battery pack for this tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it at least 3 to 5 hours prior to use.

Note: Batteries will not reach full charge the first time they are charged. Allow several cycles (drilling followed by recharging) for them to become fully charged.

TO CHARGE

• Charge battery pack only with the charger and

Do not place charger in an area of extreme heat or cold. It will work best at normal room temperature.

When batteries become fully charged, unplug charger from power supply.

SWITCH

See Figure 2.

To turn your drill ON, depress the switch trigger. To turn it OFF, release the switch trigger.

SELECTOR

SWITCH

CENTERPOSITION TRIGGER

charging stand provided.

Make sure power supply Is normal household

voltage, 120 volts, 60 Hz, AC only.

(LOCK)

VARIABLE SPEED

Fig. 2

Connect charger to power supply.

 

Place battery pack in charging stand. Align raised

 

rib on battery pack with groove in charging stand.

 

See Figure 1.

 

 

Press down

on battery

pack to be sure contacts on

 

battery pack engage properly with contacts in

 

charging stand.

 

 

• When properly connected, the red light on

 

charging stand will turn on.

 

Note: If charger does not charge battery pack, return

 

battery pack, charger and charging stand to your

 

nearest Sears Repair Center for electrical

check.

After normal usage, 3 hours of charging

time is

 

required to be fully charged. A minimum charge

 

time of 3 to 5 hours is required to recharge a

 

completely

discharged

tool.

 

The battery

pack will become slightly warm to the

 

touch while charging. This is normal and does not

 

indicate a problem.

 

 

This tool has a variable speed switch that delivers higher speed and torque with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.

Note: You might hear a whistling or ringing noise from the switch during use. Do not be concerned, this is a normal part of the switch function.

SWITCH LOCK

See Figure 2

The switch trigger can be locked in the OFF position. This feature can be used to prevent the possibility of accidental starting when not in use. To lock switch trigger, place the direction of rotation selector in center position.

_1= WARNING: Battery tools are always in operating condition. Therefore, switch should always be locked when not in use or carrying at your side.

Page 7
Image 7
Craftsman 973.111291 Charging BAI-FERY Pack, To Charge, Selector Switch Centerposition Trigger, Lock Variable Speed