Craftsman D25852, 919.769060 owner manual To Siphon CHEMICALS/CLEANING Solvents, To Shut Down

The nozzle at the end of the multi-reg wand can be rotated to change the high pressure spray pattern from a narrow jet to a 40º fan shape, as shown. Markings have been placed on the nozzle to help you select the spray pattern.

40º fan spray

narrow jet stream

For low pressure operation, extend the nozzle of the multi-reg wand as shown.

TO SIPHON CHEMICALS/CLEANING SOLVENTS

Siphoning chemicals or cleaning solvents is a low pressure operation.

NOTE: Use only soaps and chemicals designed for pressure washer use. Do not use bleach.

1.Press chemical hose onto barbed fitting located near high pressure hose connection of pump as shown.

Barb fitting

2.Place other end of chemical hose with filter on it into container holding chemical/cleaning solution.

3.Set multi-reg nozzle to low pressure setting, see How To Use Wand paragraph in this section.

4.After use of chemical, siphon clean water through chemical hose to rinse it and pump clean. Chemicals which remain in pump can damage it. Damage to pump due to chemicals will not be

covered under warranty. NOTE: Chemicals and soap will not siphon when wand is in the high pressure setting.

TO SHUT DOWN

IMPORTANT: Read and understand how to shut down the pressure washer before operating.

1.If you have siphoned chemicals, siphon a bucket of clean water through the chemical hose. NOTE: Failure to do so will cause damage to the pump.

2.Turn engine off by placing the throttle control in the OFF position.

NOTE: NEVER turn the water off with the engine running.

3.Turn the fuel valve to the OFF position if engine will not be restarted soon.

4.Turn water source off.

5.Pull trigger on spray gun to relieve any water pressure in hose or spray gun.

6.See Storage section in this manual for proper storage procedures.

D25852 12- ENG