8.Turn fuel valve to the ON position, 1/4 turn counterclockwise.
9.Move the choke control lever to
the CHOKE ON 
position and
the throttle control to the FAST
position. NOTE: No choke is
Choke
Control 
Throttle
Control
Fuel Valve Knob
needed to start a warm engine.
10.Pull starter grip slowly until you feel resistance, then pull briskly. Return starter grip gently. Pull rope with a rapid full arm stroke. Let rope rewind slowly. Repeat if
necessary.
If the engine does not start after two pulls, pull the trigger to relieve the
pressure.
11.If the choke was used to start the engine, move the choke lever to the OFF position.
12.Depress trigger on gun to start water flow. Release trigger to stop water flow.
13.Adjust nozzle spray for the task being performed. See How To Use Wand instructions in this section.
DO NOT let hoses
come in contact
with very hot engine muffler during or immediately after use of your pressure washer.
MAINTENANCE
WHEN PERFORMING MAINTENANCE, YOU MAY BE
EXPOSED TO HOT SURFACES, WATER PRESSURE, MOVING PARTS, OR FIRE RESULTING IN DEATH. BEFORE PERFORMING ANY MAINTENANCE OR REPAIR, DISCONNECT SPARK PLUG WIRE, LET ENGINE COOL AND RELEASE ALL WATER PRESSURE. THE ENGINE CONTAINS FLAMMABLE FUEL. DO NOT SMOKE OR WORK NEAR OPEN FLAMES WHILE PERFORMING MAINTENANCE.
To ensure efficient operation and longer life of your pressure washer, a routine maintenance schedule should be prepared and followed. If the pressure washer is used in unusual conditions, such as
D25852 | 14- ENG |
