30.Press a 3/4” Round Inner Cap (34) into each end of the Pad Tube (28).
Insert the Pad Tube (28) through the indicated hole in the Leg Lever (29). Slide a Foam Pad (30) onto each end of the Pad Tube.
30 |
29 |
34 |
30 |
28 |
30 |
34 |
31. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENT, beginning on page 17 of this manual. |
|
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly |
|
over the pulleys. If one of the cables does not move smoothly, find and correct the problem. | IMPORTANT: If |
the cables are not properly installed, they may be damaged when heavy weight is used. If there is |
|
any slack in the cables, you will need to remove the slack by tightening the cables. See TROUBLE- |
|
SHOOTING AND MAINTENANCE on page 18. |
|
Cable Diagrams
The cable diagrams below and on the next page show the proper routing of the Short Cable (58), the Butterfly |
|
Cable (76), and the Long Cable (23). The numbers show the correct route for each Cable. | Make sure that the |
Cables are routed correctly, that the pulleys move smoothly, and that the cable traps do not touch or |
|
bind the Cables. Incorrect cable routing can damage the weight system. |
|
2 | Short Cable (58) |
4 |
|
| 1 |
3 |
|
5 |
|
| 15 |
Butterfly Cable (76) |
4 |
2 |
5 |
1 |
3 |
