Frame Assembly

1.Before beginning assembly, make sure you have read and understood the information on page 5.

Locate and open the parts bag labeled “FRAME ASSEMBLY.”

Press a 1 1/2” Square Outer Cap (27) onto each end of the Stabilizer (5) and place it on the floor as shown.

Press a 1 1/2” Square Outer Cap (27) onto each end of the Base (4) and place it on the floor as shown.

Place the bracket on the Weight Guide (62) over the

Stabilizer (5). Note: It will be helpful to have a sec- ond person hold the Weight Guide while perform-

ing this step. Line up the holes in the bracket with the holes in the Stabilizer and insert two 5/16” x 2 1/2” Bolts (14).

See the inset drawing.

Slide the bracket on the

 

Base (4) onto the 5/16” x 2 1/2” Bolts (14) and secure

the Bolts with two 5/16” Nylon Locknuts (3).

Do not

tighten the Nylon Locknuts yet.

 

2.Place the bracket on the Upright (42) over the Base

(4).CAUTION: Make sure the Upright is oriented

as shown. Note: It will be helpful to have a sec- ond person hold the Upright while performing this step.

Line up the holes in the bracket on the Upright (42)

with the indicated holes in the Base (4). Slide a 5/16” x 2 1/4” Bolt (1) through the indicated hole and

mount a 5/16” Nylon Locknut (3) onto the Bolt.Do not tighten the Nylon Locknut yet.

Locate the Long Cable (23). It is approximately 233“ long and it has a closed loop on both ends.

See the inset drawing.

Slide a 5/16” x 3 1/4” Bolt

(33)through the closed loop on one end of the Long Cable (23). Slide the Bolt through indicated hole in the bracket on the Upright (42) and the Base (4).

Slide a 1 1/2” x 3/4” Spacer (45) and a 5/16” Flat Washer (8) onto the 5/16” x 3 1/4” Bolt (33). Hand

tighten a 5/16” Nylon Locknut (3) onto the Bolt. Note:

Leave the Nylon Locknut hand tight when you are asked to tighten the other Locknuts in step 6.

6

1

 

 

5

 

14

62

3

 

 

4

 

3

14

5

27

 

27

3

 

 

27

 

3

 

4

 

27

2

 

 

 

Make sure the

 

 

 

 

bracket is on

 

 

 

 

this side

 

 

42

 

23

 

 

 

 

 

 

 

 

4

 

 

 

 

33

 

 

 

 

8

 

 

 

3

45

 

 

 

 

 

 

 

 

23

 

 

 

45

33

 

 

 

 

 

 

 

8

 

 

 

 

 

1

 

4

 

3

 

 

 

 

 

 

 

 

3

 

Page 6
Image 6
Weider 740 Locate and open the parts bag labeled Frame Assembly, See the inset drawing, Bolts with two 5/16 Nylon Locknuts