Weider 740 user manual Top Frame Weight Guide Tube, Locate and open the parts bag labeled ARM

6.Attach the two tubes on the Weight Guide (62) to the Top Frame (55) in the following manner:

Slide a 5/16” x 6” Bolt (7) through one of the tubes on the Weight Guide (62) until the tip is barely visible on

the other side. Position a 1/2” x 1” Spacer (51) and slide the Bolt through it. Then slide the Bolt through

one sidewall of the Top Frame (55).

Position a 1/2” x 1 3/8” Spacer (61) inside the Top

Frame (55) and slide the 5/16” x 6” Bolt (7) through it. Then slide the Bolt through the other sidewall of the

Top Frame.

Position a 1/2” x 1” Spacer (51) and slide the 5/16” x 6” Bolt (7) through it. Then slide the Bolt through the other tube on the Weight Guide.

Secure the 5/16” x 6” Bolt (7) with a 5/16” Nylon Locknut (3) do not tighten at this time.

Tighten all Nylon Locknuts (3) used in steps 1-6.

Arm Assembly

6
	61
	51	3
	51	55
	7
		62
	Schematic view from the back
	Top Frame
	(55)
3	51	51	7
	61
Weight Guide Tube		Weight Guide Tube

7. Locate and open the parts bag labeled “ARM	7			16 Lubricate
ASSEMBLY.”
Press a 1 1/2” Square Inner Cap (32) into the open	55
tubes on the Press Frame (17).				32
		21
Align the welded spacers on the Press Frame (17)
				Welded
with the indicated holes in the Top Frame (55).
		32		Spacers
Lubricate the 3/8” x 6” Bolt (16). Attach the Press
Frame to the Top Frame with the Bolt and a 3/8”
Nylon Locknut (21).				17
Make sure the welded tab on the Press Frame (17)				Welded Tab
is oriented as shown.
8. Press a 1 3/4” Square inner Cap (77) into each end	8		48
of the Right Arm (48).
Wet the lower end of the Right Arm (48) with soapy	77		10	52
			2
water and slide a Foam Roller (71) onto the Arm.
	48
		46
Press a 1” Round Inner Cap (49) into each end of a				77
Press Handle (46). Attach the Press Handle to the
Right Arm (48) with a 1/4” x 1 3/4” Screw (52), a 1/4”			49
Flat Washer (10) and a 1/4” Nylon Locknut (2).
Repeat this procedure for the Left Arm (47).				71

8