LATITUDE LARGE MEDIA STAND
1Place 4 legs at each corner of the base frame, aligning hole in leg with hole in bracket. Attach with 1 leg bolt per leg, fully tightening with a phillips head screwdriver.
Do not over tighten the screws.
2Position base frame assembly over holes in the bottom panel. Insert 12 wood screws through holes in frame and into bottom panel and secure with a screwdriver.
A
Top
Make sure arrow on each cam points to nearest
Aedge with dowels
Panel
B
Bottom
Panel
C
Side
Panel
B
D
3A. Insert 12 cam screws into the inner holes of the top panel. Secure, but do not over tighten with a screwdriver. B. Insert 12 cam screws into the inner holes of the bottom panel and secure with a screwdriver.
Made in Denmark - r09
4A. Insert 6 wood dowels in the outer holes on the edge of each side panel.
B. Insert 6 cams into each side panel, making sure arrow of each cam points out towards nearest edge with dowels.
C. Fasten 2 cam screws at rear inner hole on each side panel with a phillips head screwdriver.
D. Attach 2 case hinges to each side panel with 2 hinge screws. Use the top 2 holes for the top case hinge and the bottom 2 holes for the bottom case hinge as shown.
Page 2 of 5
Customer Service