C R A T E 
8 |
|
|
|
|
|
|
|
17 | 18 | 19 | 20 | 21 | 22 | 23 | 24 |
14.LOW (Active only with the Channel Select switch out): Use this control to adjust the low frequency level for the instrument channel 2.
15.MID (Active only with the Channel Select switch out): Use this control to adjust the mid frequency level for the instrument channel 2.
16.HIGH (Active only with the Channel Select switch depressed): Use this control to adjust the high frequency level for the instrument channel 2.
17.LEVEL (Active only with the Channel Select switch out): Use this control to adjust the out- put level of the instrument channel 2.
18.DSP SEND: Use this control to adjust the amount of signal sent to the internal Digital Signal Processor (DSP) for the instrument channel.
19.DSP MODE: Use this control to select the type of Digital Signal Processing (DSP) effect applied to the signal. The nomenclature around the control is as follows:
BYPASS: No effect applied
SLAP: Moderate slapback delay
DELAY: Moderate delay with regeneration
ECHO: Long delay with regeneration CHORUS: Moderate chorus effect ROTARY: Simulated rotating speaker effect
CHO/HALL: Chorus combined with large reverb
ROOM: Small reverb effect
HALL: Large reverb effect
20.CD INPUT: Use these jacks to connect the outputs of a CD player or tape player to the amplifier. The output of the CD or tape player may need to be attenuated for a suitable mix with the input channels – see the notes on page
21.FOOTSWITCH: Use this jack to connect a footswitch to the amplifier for remote control of the Instrument channel selection and turning the DSP on and off. The jack is wired as fol- lows:
Tip = Instrument channel selection
Ring = DSP control
Sleeve = ground
22.HEADPHONES: Use this jack to connect a pair of stereo headphones for private practice sessions. The internal speakers are discon- nected when headphones are used.
23.LED: This LED illuminates yellow when the power switch is at the on position – when the amp is fully charged. The LED illuminates red when the battery needs recharging.
24.POWER: Use this switch to turn the amplifi- er on (top of the switch depressed) and off (bot- tom of switch depressed).
7
