Installation Instructions
Gas Safety
(Installation & Use)
Regulations
Location
Prior to installation, ensure that the local distributions (nature of the gas and gas pressure) and the adjustment conditions are com- patible. The adjustment conditions for this appliance are stated on the data badge which is fitted below the oven door on the plinth panel. This appliance is not designed to be connected to a com- bustion products evacuation device. It must be installed and con- nected in accordance with current installation regulations. Particular attention should be given to the relevant requirements regarding ventilation.
MODEL NUMBERS 41202, 41203, 41204, 41205 Category I2H (G.B. IE)
These models are set to burn NATURAL GAS (G20) at 20 mbar ONLY and cannot be used on any other gas.
MODEL NUMBERS 41212, 41213, 41214, 41215 Category I3+ (G.B. IE)
These models are set to burn PROPANE GAS (G31) AT 37 mbar and BUTANE GAS (G30) AT 28 - 30 mbar and cannot be used on any other gas
It is the law that all gas appliances are installed by competent persons in accordance with the current edition of the above regu- lations. It is in your interest and that of safety to ensure compli- ance with the law.
In the UK, CORGI registered installers work to safe standards of practice.
The cooker must also be installed in accordance with BS 6172: 1990.
Failure to install the cooker correctly could invalidate the warranty liability claims and could lead to prosecution.
The cooker may be located in a kitchen, kitchen/diner or a bed- sitting room, but not in a room containing a bath or shower. The cooker must not be installed in a
L.P.G. models 41212, 41213, 41214 & 41215 must not be installed in a room or internal space below ground level e.g. in a base- ment.
Provision for Ventilation
The room containing the cooker should have an air supply in accordance with BS 5440: Part 2: 1989.
The room must have an opening window or equivalent; some rooms may also require a permanent vent. If the room has a vol- ume between 5 and 10m3, it will require an air vent of 50cm2 effec- tive area unless it has a door which opens directly to outside. If the room has a volume of less than 5m3, it will require an air vent of 100cm2 effective area. If there are other fuel burning appli- ances in the same room, BS 5440: Part 2: 1989 should be consulted to determine air vent requirements.
19
