Creda S230G installation instructions Something Wrong?, Problem, Check, There May Be Nothing Wrong

SOMETHING WRONG?

Before calling a Service Engineer, please check through the following lists.

THERE MAY BE NOTHING WRONG.

Problem	Check
Nothing works.	If the timer display is blank.
	Then it is likely that there is no electricity supply to your oven.
	Check: (i) That the main cooker wall switch is turned on.
	(ii) Check other appliances to see if you have a power cut.
	(iii) Check the main circuit breaker for the property.
Display shows 0.00 AUTO.	The power supply to your oven has possibly been interrupted, but has
	now come back on again. Reset the timer to the correct time of day and
	"Manual" operation using instructions given in the timer section of the
	book.
Timer display shows " Auto " lit	To use the ovens or grill the timer must be set to manual mode. See timer
up or flashing.
	instructions.
Timer display correct but	The appliance incorporates a safety device to shut down the burners in
appliance will not operate	the event of a fault, to prevent overheating.
	In this case contact your service engineer to have the fault rectified and
	the safety device reset.
Can not set an “Auto Cook”	Remember that " Cook period " is the actual length of time for which the
programme	timer will switch the oven(s) on as part of an "Auto cooking " pro-
	gramme.
Draught from beneath control	A gentle flow of air will be blown from beneath the control panel when
panel.	the appliance is used. If the appliance is still warm, this cooling fan may
	continue to run, or restart itself after all controls have been turned off.
	The fan will stop once the appliance has cooled.
Cooling fan not operating	If no air is blown from below the control panel when the controls are
	switched on and you have checked through the " Nothing works "
	section above, then the cooling fan may be faulty. In this case you should
	turn off the appliance and contact your service agent to arrange for a
	repair.
Oven burner not working	Note that the oven burners only operate when the door is closed to
	ensure safe operation and avoid wasting heat. With the door closed the
	oven burner will ignite.
Oven appears to be cooking at	It may be necessary to turn to a lower setting than shown on the cooking
too high a temperature.	chart or recipe as results depend on personal tastes.
	If the oven appears to be cooking at too high a temperature than
	previously, and turning down the thermostat has no effect, then the
	thermostat may be faulty and you should contact your service agent.
Timer buzzer/bleeper operates	Buzzer / bleeper should stop automatically after two minutes. If not.
continually	press minute minder button to silence.

If you have been through the above list and there is still a problem; contact our Service department

(see Key Contacts, back page).

33