Creek Audio Destiny Rds Fm/Am Tuner Operating Instructions, Safety Instructions Cont’D, Tuning

DESTINY RDS FM/AM TUNER OPERATING INSTRUCTIONS

SAFETY INSTRUCTIONS CONT’D

DAMAGE REQUIRING SERVICE

Stop using the unit immediately and have it inspected by an authorised service centre whenever:

1.The power supply cord or plug has been damaged.

2.Liquid has been spilled into the unit.

3.The unit has been exposed to rain.

4.The unit does not operate properly.

5.The unit has been dropped or damaged.

6.Smoke or any unusual smell is detected from the unit.

CAUTION: To reduce the risk of electric shock, do not remove cover. No serviceable parts inside.

FRONT PANEL

FRONT PANEL CONTROLS & OPERATION

STANDBY

Press this button to turn the tuner on and off. In standby, this product draws less than 1 Watt of power. However, if you are leaving the unit switched off for a long period, it is advisable to switch it off permanently by using the POWER SWITCH on the rear panel.

TUNING

Turn the knob left or right to manually fine tune stations after switching Mode to tuning. When tuned to the maximum frequency, it is possible to go to the minimum frequency quickly by continuing to turn the knob clockwise. The frequency will flip to the bottom 87.5Mhz on FM.

PRE-SET

Steps up or down through pre-set stations by turning the knob on the right after switching Mode to Pre-set. When using Pre-set mode, after reaching the last stored station in FM, the tuner will flip to any stored stations in AM, then back to FM if the knob is turned back or forward through all of the stored AM stations.

MODE

Press this button to select manual tuning or pre-set mode, when using the knob on the right of the panel. The button toggles between the 2 functions and the display will either show the pre-set station number, say 12F, for the station pre-set 12, or it will show 00F at the beginning to indicate free tuning and not pre-set.

SCAN

Pressing the Scan button will automatically search for the next tuned (strong) station. If you want to keep it, follow the "Store" procedure described below.

STORE

Use to set a station pre-set. Tune to the station you wish to save as a pre-set. Press the STORE button then press the MODE button (to select the PRE-SET mode). The band (FM or AM) and a pre-set number will be displayed and begin to flash. Turn the tuning/preset knob on the front panel until the desired number is displayed then press the STORE button. Any number from 1- 80 can be used for AM or FM pre-sets. Pre-sets can be set faster by using the remote control.

Page Two