Destiny Stereo Power Amplifier
A second set of terminals marked ‘B’ allows the user to select from the loudspeaker push buttons on the left side of the front panel. The options include Speakers Off (when using headphones), Speakers A, Speakers B or Speakers A+B together. It is NOT recommended to use loudsepakers of less than 4 Ohms resistance or more than 2 pairs of 8 Ohm speakers running in parallel from the amplifier at one time. However
IMPORTANT Do not short the loudspeaker cables together when the other ends are still connected to the amplifier, as permanent damage can result. If it is necessary to move or change the location of the loudspeakers, make sure that you first switch off the amplifier from the mains, or select Standby.
LED Indicators
When the Destiny Stereo Power Amplifier is first switched on, the power LED will glow orange while in Standby. By waking the amplifier from Standby, the LED will then turn green. When using this power amplifier in conjunction with the Creek Destiny Integrated Amplifier, pressing the MUTE button on the Creek SRC2 system remote handset will cause the speaker selection LED’s to turn orange. Pressing the button again will
Please note that muting can only be cleared by the Creek SRC2 system remote handset or by pressing the power amplifier standby switch.
If the amplifier stops working and the Power LED turns red, it indicates a fault. Return the amplifier to the supplying dealer for inspection.
Remote Control
The Creek SRC2 System Remote Control handset supplied with the Destiny Integrated Amplifier and Destiny source products allows the user to operate the Destiny Stereo Power Amplifier power on/off, loudspeaker selection and mute by an
Protection Modes
The Destiny Stereo Power Amplifier has a sophisticated, computer controlled, protection mechanism against
If the amplifier is driven hard for a long time and has insufficient ventilation, or if the ambient temperature is high, the signal will be muted to enable the amplifier to cool down to an acceptable working temperature. If the output load is too low and the input signal too high it will overdrive the amplifier. So, for a short period of time, the amplifier will be muted. Reducing the input level will restore the correct operation.
If direct current (DC) is input to the Destiny Stereo Power Amplifier, it will sense this and cause the output to be disconnected, to avoid damaging the voice coil of the loudspeakers. In the event of a failure of the amplifier, the speaker output and/or the mains supply will be disconnected. This may require it to be returned to the dealer for servicing. Please check with the dealer first for advice.
Creek Link
Destiny products have a special (CAN bus) serial link to enable them to be joined together and controlled and viewed from a remote location,such as another room. This will require an optional CAN to RS232 adapter and proprietary room controller. Check Creek's website for release date details.
Radio Interference
The Destiny Stereo Power Amplifier is designed to work properly in normal domestic operating conditions. However the amplifier’s performance may be affected if sited near to a radio transmitter such as a mobile phone etc.
Your Destiny Stereo Power Amplifier is designed to give you years of reliable use. If you need more assistance, it is always advisable to go back to the supplying dealer for his expert help. If you are unfortunate enough to need service work to be carried out on your amplifier, it should be returned to your dealer in the original packing if possible.
3
