Crestron electronic C2N-DAP8RC Setup , R

Operations Guide – DOC. 8187A Digital Audio Processor with Room Control: C2N-DAP8RC • 11

These three potentiometers are used to adjust the respective video input signal to

compensate for signal losses due to long cable runs. Refer to the section titled

“Video Input Compensation for CAT5 Inputs” on page 23 for detailed procedures.

As of the date of manufacture, this unit has been tested and found to comply with

specifications for CE marking and standards per EMC and Radiocommunications

Compliance Labelling (N11785).

NOTE: This device complies with part 15 of the FCC rules. Operation is subject to

the following two conditions: (1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.

Setup

CAUTION: Use only Crestron power supplies for Crestron equipment. Failure to do

so could cause equipment damage or void the Crestron warranty.

CAUTION: Provide sufficient power to the system. Insufficient power can lead to

unpredictable results or damage to the equipment. Please use the Crestron Power

Calculator to help calculate how much power is needed for the system.

http://www.crestron.com/dealer-tech_resources/power_calculator.asp

NOTE: When installing network wiring, refer to the latest revision of the wiring

diagram(s) appropriate for your specific system configuration, available from the

Downloads | Product Manuals | Wiring Diagrams section of the Crestron website

(www.crestron.com).

When calculating the wire gauge for a network run, the length of the run and the

power factor (power usage in watts) of each network unit must be taken into

consideration. If multiple network units are to be daisy-chained, the power factors of

each unit must be added to determine the power factor of the entire chain. The length

of the run in feet and the power factor of the run (in watts) should then be used in the

following resistance equation.

R = Resistance (refer to table below).

L = Length of run (or chain) in feet.

PF = Power factor of entire run (or chain).

40,000 Where:

The required wire gauge should be chosen such that the resistance value is less than

the value calculated in the resistance equation. Refer to the table after this paragraph.