Uninterruptible Power Supply Crestron CEN-UPS1250
“DISPLAY DIMMER” Screen
DISPLAY DIMMER:HIGH
PRESS TO CHANGE
LED DIMMER setting – This screen lets you set a brightness level of HIGH, LOW
or OFF for the front panel LED indicators. Press the up/down arrow buttons to set
the brightness level of the LEDs.
“LED DIMMER” Screen
LED DIMMER:HIGH
PRESS TO CHANGE
GO TO BAT IF < XXXV setting – This setting allows you to set a low voltage
threshold for the unit, which will force it to switch to power from the internal battery
pack when the threshold is reached. Settings range from 92 to 100 Volts.
“GOTO BAT IF < XXV” Screen
GOTO BAT IF < 100V
PRESS TO CHANGE
GO TO BAT IF > XXXV setting – This setting allows you to set a high voltage
threshold for the unit, which will force it to switch to power from the internal battery
pack when the threshold is reached. Settings range from 134 to 142 Volts.
“GOTO BAT IF > XXV” Screen
GOTO BAT IF > 134V
PRESS TO CHANGE
OUTLET DELAY1 and OUTLET DELAY2 setting – These settings let you define a
time delay (0 to 10 seconds) for when the unit provides power to the rear panel
outlets marked BANK 3 and BANK 4 respectively. By setting this delay, it prevents
power on or power off glitches from affecting other equipment connected to the unit.
“OUTLET DELAY1” Screen
OUTLET DELAY1:5SEC
PRESS TO CHANGE
28 • Uninterruptible Power Supply: CEN-UPS1250 Operations & Installation Guide – DOC. 6635A