Crestron MPS-300 Multimedia Presentation System 300 DIP Switch Location
DIP SWITCHES LOCATED UNDER ACCESS PANEL
Set the DIP Switches 1. Referring to the following table, set the DIP switches of each RGB input
port to the required sync input impedance and DDC functionality.
DIP Switch Function Chart
DDC HORIZONTAL
SYNC VERTICAL
SYNC
SWITCH 1 2 3 4 5 6
FUNCTION SETTING
OFF OFF OFF X X X X
DDC ON ON ON X X X X
1K X X OFF OFF OFF OFF
500 X X ON OFF ON OFF
SYNC INPUT
IMPEDANCE 75 X X ON ON ON ON
NOTE: The function table is also located on the bottom of the MPS-300.
NOTE: The factory setting for the DIP switches are DDC disabled
(switches 1 & 2 in the OFF position) and 1k ohm impedance (switches 3
through 6 in the OFF position).
2. Replace the access panel and secure the screws using the #2 Phillips
screwdriver.
Further Configuration If using the out-of-the-box functionality, the MPS-300 can be configured with the
front panel. For information, refer to “Configuration” on page 36.
Operations Guide – DOC. 6529B Multimedia Presentation System 300: MPS-300 • 29