OPTION PROGRAMMING
To Engage Option Programming:
1.Turn Key to the ON position and wait 5 seconds.
2.Press program / valet button 5 times, after a few seconds the unit will flash the lights 5 times and the LED will light solid.
3.Push the valet/program button [again] the number of times that corresponds to the option number desired (1 thru 13). Press so that you get a light flash after each button press. If the unit did not flash the lights, then it did not register your press. See chart below for option list.
4.When you reach the desired programming level, Press button #1(Lock) or #2 (Unlock) to change the option. Pressing button 1 will provide one light flash and pressing Button 2 will provide 2 light flashes.
5.Turn Ignition OFF and check for changed features. Change each option individually repeating steps
*=Factory Default Value
Option # | Option Description | Lock Button #1 | Unlock Button #2 |
1 | Auto lock with Ignition | OFF | *ON |
2 | Passive Arming | ON | *OFF |
3 | Active | ON | *OFF |
4 | Passive Locks | ON | *OFF |
5 | Parking Lights on w/Disarm | OFF | *ON |
6 | GRAY wire programming | M.A.P. On in | *Trunk Pop |
|
| Valet Park | (Aux. #1) |
7 | Type of Carjack protection: | Passive | *Active |
| Active or Passive Carjack |
|
|
8 | Disarm on Trunk pop | OFF | *ON |
9 | Open Door Warning | 5 Sec. | *60 Sec. |
10 | Door Lock Pulse Time | 3 Sec. | *0.75 Sec. |
11 | Double Unlock Pulse | 2 Pulses | *1 Pulse |
12 | Enable / Disable Carjack Features | Enable | *Disabled |
13 | Starter Disable Relay Config. | Normally Open | *Normally Closed |
14 | Option reset |
| Reset options |
1. AUTOLOCK WITH IGNITION
This option controls whether the doors will automatically lock when the ignition is turned on and will unlock when the
ignition is turned off. | 11 |
|