Crimestopper Security Products CS-2004TW1 manual Pink Wire + Carjack Input, Pinsensor Plug, Wiring

WIRING

WHITE/RED WIRE: (-) REMOTE OUTPUT #2 (Optional, Requires Relay)

This wire provides a momentary (-) Negative auxiliary Output when Button #4 is pressed and held for at least 2 seconds. Connect this wire to terminal 85 of a relay to operate an AUX device or function. Connect terminal 86 or the relay to +12 Volts constant. Connect terminal 87 to 12Volts or Ground depending to the type of circuit needed. Connect Terminal 30 to the AUX device’s activation wire. This output will stay activated as long as the button is held down.

PINK WIRE: (+) CARJACK INPUT

Connect to a push button, toggle switch, or to a +12 Volt source to selectively activate Car Jack protection features - See diagram on next page for example wiring configuration. This wire is used to activate a passive carjack trigger even if the Carjack features are not turned on in the programming options. A Carjack countdown will begin under the following conditions: Ignition is ON (vehicle is running), the button or toggle switch is pressed, and a door opens

&closes. Upon these 3 events, in that order, the alarm will start a Carjack countdown. See “Carjack protection” section on page

OPTIONAL CAR JACK WIRING: SWITCH
HIDDEN BUTTON or	+
TOGGLE SWITCH
	+12 V
(Not Included)
PINK

2-PIN PLUG (SMALL): LED INDICATOR (RED FLASHING LIGHT)

2-PIN PLUG (MEDIUM): PROGRAM/OVERRIDE PUSH BUTTON

4-PIN SENSOR PLUG:

RED WIRE SENSOR +12V POWER

BLACK WIRE SENSOR GROUND

BLUE WIRE: NEG. WARN AWAY

WHITE WIRE: NEG. TRIGGER

3-PIN BLUE SENSOR #2 PLUG: (For adding additional sensors)

PIN 1: SENSOR +12V POWER
PIN 2: NEGATIVE (-) TRIGGER
PIN 3: SENSOR GROUND	5

TIP: The Sensor supplied with this system does not require any additional wiring, simply mount the sensor in a suitable location, plug in, and adjust to the desired levels of sensitivity. The Black dial is for Pre-warn level and White dial is for Shock trigger.