Crimestopper Security Products CS-2004DC, CS-2004TW1 manual Starter Disable Wiring

STARTER DISABLE WIRING

STARTER DISABLE PLUG: 3 ORANGE 14 GA. WIRES:

(PROGRAMMABLE: Normally Closed or Normally Open Configuration with ON-Board Relay)

Note: READ BELOW before connecting starter disable! Normally OPEN must be programmed to operate. See pg 10.

Normally Closed Starter disable is the standard type used with most alarm systems today. This circuit will disable the Starter while the alarm is armed or has been triggered. If 12V power is removed from the system, the Battery goes dead, the relay will revert back to the closed position. (Factory Default)

Normally Open Starter Disable is a High-Security circuit that will disable the starter while the alarm is armed or triggered AND if the unit is unplugged or removed from power. This means that if the vehicle’s Battery goes dead or the unit is unplugged from the vehicle, the car will still not start. We only recommend this type of circuit if you can install a hidden high- current toggle switch to defeat the Normally Open disable in case of a dead battery or if the unit is unplugged/remove for service. (Toggle not included) See programming option #13 on page 10 to enable this type of starter disable.

IGN	NORMALLY CLOSED STARTER DISABLE (DEFAULT)
SWITCH	START WIRE
	CUT

ORANGE N/C

ORANGE COM

ORANGE N/O

NOTE ALIGNMENT OF PLUG N/C = NORMALLY CLOSED

STARTER

NORMALLY OPEN STARTER DISABLE (OPTIONAL)

IGN

SWITCH

START WIRE	CUT
	STARTER

ORANGE N/C

ORANGE COM

ORANGE N/O

**JUMPER #7 MUST BE	NOTE ALIGNMENT OF PLUG	HIDDEN TOGGLE
	N/O = NORMALLY OPEN	SWITCH
REMOVED!**
		(NOT INCLUDED)

8