STEP 4. Preparation of the Dryer
Prior to the first use of this appliance, use all purpose cleaning products or a solution of detergent and water, with damp cloth to remove from the inside of the dryer drum/drying compartment any dust or dirt that may have accumulated inside the dryer.
STEP 5. Confirming Heat Source Operation
Confirming Heat Source in Electric Dryers
Close the door to the dryer drum/drying compartment and, after completing all steps in this manual for proper installation of this dryer, start the dryer on a heat setting.
The exhaust air or the exhaust pipe should be warm after the dryer has been operating for three minutes.
STEP 6. Dryer Airflow
Effective dryer operation requires appropriate dryer airflow.
The adequacy of the airflow can be measured by evaluating the static pressure.
Static pressure in the exhaust duct can be measured with a manometer, placed on the exhaust duct approximately
1 ft. (30.5cm) from the final outlet.
Static pressure in the exhaust duct should not exceed 7.6mm water column.
The dryer should be checked while the dryer is running with no load.
STEP 7. Procedure for Reversing the Door
The door on your dryer can be installed to open either to the left or the right. Follow these instructions to reverse the direction in which your door opens:
Note : Door and latch should be aligned at the center when closed.
11
