3 Setup (continued)
3.6 Wire Your System
3.6.1 Stereo Mode
Typical input and output wiring is shown in
Figure 3.6.
INPUTS: Connect input wiring for each channel. Refer to Section 3.4 for input connector pin assignments.
OUTPUTS: Maintain proper polarity
Connect positive (+) speaker lead to Channel 1 positive output of amp; connect negative
Figure 3.6 System Wiring, Stereo Mode
3.6.2 Bridge-Mono Mode
Typical input and output wiring is shown in
Figure 3.7.
INPUTS: Connect input wiring to Channel 1. Refer to Section 3.4 for input connector pin assignments.
OUTPUTS: Connect positive (+) speaker lead to Channel 1 positive output of amp; connect nega- tive
NOTE: Turn down (full CCW) the Channel 2 level control when operating in Bridge- Mono mode, as the
Figure 3.7 System Wiring, Bridge-Mono Mode
Operation Manual | page 9 |