Cub Cadet 2206 manual Front Lift ROD Front Roller Bracket Slots

11.Pull the deck support pins outward, turn downward and release so both spring-loaded pins are held in the disengaged position against the outer surface of the deck brackets (Refer to Figure 52).

LIFT

LINK

REAR DECK	DECK SUPPORT
BRACKET	PIN DISENGAGED
	(BOTH SIDES)

Figure 52

12.Raise the tractor implement lift handle to its highest setting. Roll the mower deck forward until the front lift rod slides up and out of the openings of both front roller bracket slots. Manually lift the rod out of the slots if necessary (See Figure 53).

13.Raise the front lift rod upward and slide the mower deck rearward. Lower the front lift rod so it rests on the front roller bracket of the deck, forward of the slots (Refer to Figure 53).

FRONT LIFT ROD

FRONT ROLLER

BRACKET SLOTS

Figure 53

14.From the front of the tractor, push downward and hold the tractor quick-attach rod. Pull the front lift rod/bracket assembly forward to release the shoulder bolts on each side of the bracket from the left and right tractor latch receivers. Release the tractor quick-attach rod ( Refer to Figure 54).

TRACTOR

LATCH RECEIVER

(BOTH SIDES)

QUICK

ATTACH

ROD

SHOULDER BOLT

(BOTH SIDES)

FRONT LIFT ROD/BRACKET

ASSEMBLY

Figure 54

CAUTION

To avoid possible equipment damage, make sure that the tractor implement lift handle is raised to its highest setting before sliding the deck out from under the tractor.

NOTE: To aid in sliding the deck out from under the tractor, turn the steering wheel as needed to obtain more room as you maneuver the deck from under the tractor.

15.With the tractor implement lift handle raised to its highest setting, slide the deck to the right and out from under the tractor (Refer to Figure 55).

16.Connect the spark plug wires and close the tractor hood.

SLIDE

OUT

Figure 55

39