SPARK PLUG
WARNING
To avoid possible injury, be sure the engine is off and has cooled before making any adjustments or repairs.
NOTE
Remove all dirt from around the spark plug before removing.
To remove the spark plugs, always use a spark plug wrench. Check the gap after every 100 hours of operation.
Replace a defective plug with a new plug. Set the spark plug gap at .030 inch (See Figure 24). Tighten the plug to
SPARK PLUG
Figure 24
FUEL FILTER
WARNING
Do not replace the fuel filter when engine is hot.
The engine is equipped with an inline fuel filter. Visually inspect the filter periodically for a
HEADLIGHTS
Refer to SPECIFICATIONS when replacement of head lamp bulbs is necessary.
WARNING
Allow the engine and surrounding surfaces to cool before changing the head lamp bulbs.
Replace headlight bulbs as follows: (See Figure 25)
1.Unplug the wire harness leads from the headlight socket terminals. Note which wire connects to each terminal before disconnecting.
2.Rotate the socket assembly as follows to remove from the reflector housing:
•Left headlight — appoximately 1/4 turn counter- clockwise.
•Right headlight — approximately 1/4 turn clock- wise.
3.Push the bulb inward and turn counterclockwise to remove from the socket.
TERMINAL
SOCKET TAB
SOCKET
REFLECTOR | REFLECTOR | |
NOTCH | ||
HOUSING | ||
|
Figure 25
4.Align a locking post of the bulb base with the notch in the socket, then push the bulb inward and turn clockwise to lock
5.With the terminals pointing upward, align the tab of the socket with the notch of the reflector. Push the socket inward and turn as follows to lock:
•Left headlight — appoximately 1/4 turn clock- wise.
•Right headlight — approximately 1/4 turn coun- terclockwise.
6.Connect the wire harness leads to the appropriate socket terminals.
29