33
Tools Needed:
None
| Drum |
Drum Wrap Installation | Wrap |
| |
Drum wraps are identified as right and |
|
left hand. | Outside |
To install, place the drum wrap over the | Flange |
| |
cable drum and under the idrive® |
|
disconnect cable (right hand side). Align |
|
the outside flange over the outside edge |
|
of the cable drum and push the drum | Cable |
wrap down onto the cable drum. Repeat | Drum |
for left hand side. |
|
NOTE: Drum wraps must be installed to prevent cable from becoming tangled.
IMPORTANT: Right and Left hand are always determined from inside the building looking out.
Cable
Drum
Drum
Wrap
34 | Rear Support | DOOR IN THE | |
| |||
Tools Needed: | WARNING | UP POSITION | |
| |||
|
| ||
Ratchet Wrench | Keep horizontal track |
| |
1/2” Socket | parallel and within 3/4” |
| |
maximum of door edge, |
| ||
1/2” Wrench | otherwise door could fall, |
| |
| resulting in severe injury or |
| |
(2) Vice Clamps | death. |
| |
Tape Measure | Raise the door until the top section and |
| |
half of the next section are in a horizontal |
| ||
|
| ||
Level | position. Do not raise door any further |
| |
Hammer | since rear of horizontal track is not yet | 3/4” | |
supported. | |||
|
| ||
| WARNING | DOOR edge | |
| Raising door further can | ||
| result in door falling and |
| |
| cause severe injury or death. |
| |
| Clamp a pair of vice clamps on the vertical |
| |
| tracks just above the second roller on one |
| |
| side, just below the second roller on the |
| |
| other side. This will prevent the door from | Horizontal | |
| raising or lowering while installing the rear | ||
| TRACK | ||
| support. | ||
|
| ||
| Using perforated angle, 5/16” x |
| |
| hex head lag screws and 5/16” bolts with |
|
30
vice clamps
vertical
TRACK
Please Do Not Return This Product To The Store. Contact your local
local yellow pages/business listings or go to the Find a Dealer section online at