❉
Tools Needed:
7/16” Drill Bit
Power Drill
7/16" Wrench
Step Plate
Make one mark 1” (25 mm) up from the center of bottom edge of the bottom section and another mark
Drill a 7/16” (11 mm) hole through the section at each mark and insert the outside step plate.
Loosely fasten step plate slide to base with
(1) 1/4” - 20 x 5/8” carriage bolt and nut.
Align inside step plate holes and fasten from inside using the #8 screws provided. Install one #8 x 3/4” screw in the bottom step plate hole. The screw in the top hole varies with door models.
Use the screw size shown below for your model door.
a)#8 x 3/4” screw for Model 9100
b)#8 x 1” screw Model 9400/9600
Tighten 1/4” - 20 carriage bolt and nut.
| STEP PLATE OUTSIDE |
| |
| step plate | STEP PLATE INSIDE | |
1/4” - 20 x 5/8” | base | Assembled | (2) #8 screws |
| |||
carriage bolt |
| Step Plate |
|
|
|
| |
step plate | hex nut |
|
|
slide |
|
|
❉
Tools Needed:
Power Drill
1/8” Drill Bit
Pull Rope
WARNING
DO NOT INSTALL PULL ROPES ON DOORS WITH ELECTRIC OPERATORS. CHILDREN MAY BECOME ENTANGLED IN THE ROPE CAUSING SEVERE OR FATAL INJURY.
Measure and mark the jamb approximately 48” to 50” (1220 to 1270
mm)from floor on the right or left side of jamb. Drill 1/8” pilot hole for No. 6 screw eye. Tie the pull rope to the No. 6 screw eye and to the bottom bracket as shown.
NO. 6 SCEW EYE
PULL ROPE
BOTTOM BRACKET
PULL ROPE
OPTIONAL INSTALLATION
33
Please Do Not Return This Product To The Store. Contact your local
local yellow pages/business listings or go to the Find a Dealer section online at