Wayne-Dalton 9600 installation instructions Bottom Section, Vertical Track

6

Tools Needed:

Level

Bottom Section

Before installing the bottom section, the weather seal (may not be included) must be installed (see Preparing the Opening on page 10)

Center the bottom section in the door opening. Level section using wooden shims (if necessary) under the bottom section.

weather seal

door opening level

SECTION
BOTTOM	wooden shims

(if necessary)

7

Tools Needed:

3/16” Drill Bit

Power Drill

7/16” Socket

Driver

Tape Measure

Level

Vertical Track

IMPORTANT: The tops of the vertical tracks must be level from side to side. If the bottom section was shimmed to level it. The vertical track on the shimmed side, must be raised the height of the shim.

Position the left hand vertical track assembly over the rollers of the bottom section. Make sure the counterbalance cable is located between the rollers and the door jamb. Drill 3/16” pilot holes for the lag screws. Loosely fasten

cable drum fLAGANGLE

5/16” x 1-5/8”

LAG SCREWS

CABLE

VERTICAL

TRACK

ASSEMBLY

vertical track

BOTTOM SECTION

5/8” roller

LAG	LAG
	SCREW
SCREW
	locations
locations

jamb brackets and flagangle to the jamb using 5/16” x 1-5/8” lag screws. Tighten lag screw securing bottom jamb bracket to jamb, to maintain 5/8” spacing. Hang cable drum over flagangle. Repeat for the right hand side.

JAMB

BRACKET SECTION BOTTOM

12r qi flagangle 15r qi flagangle

quick install jamb bracket

LAG SCREW

locations

	lag
12r & 15r Fully	screw

Adjustable flagangle

14

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com