Wayne-Dalton 9600 Drive Gear Installation, End Brackets, Socket Driver Phillips Head Screwdriver

21

Tools Needed:

Lubricating Oil

36 Tooth Worm

Gear

Drive Gear Installation

Beginning with the right hand side, lubricate entire circumference of the 36 tooth worm gear with the lubricating oil provided. Slide the 36th worm gear onto the winding shaft splines until it touches the flagangle.

NOTE: On single spring applications, no drive gear is required on the left side.

NOTE: If additional lubricating oil is needed, use “Dura Lube® Engine Oil Treatment”.

Cable

Drum Winding Shaft

Splines lubricating oil

36 tooth

worm gear

Flagangle

Cable

Drum

36 tooth worm gear

Winding

Shaft

INSTALLATION

22

Tools Needed:

Power Drill

3/16” Drill Bit

7/16”

Socket Driver

Phillips Head

Screwdriver

End Brackets

IMPORTANT: Warning Tags must be securely attached to both End Brackets.

Slide the right hand end bracket over the drive gear and fasten to the flagangle using a #10 self-tapping screw. Drill 3/16” pilot holes into jamb for the lag screws. Secure end bracket and the flagangle to the jamb using (2) 5/16” x 1-5/8" lag screws.

Repeat for left hand side.

End Bracket

(2) 5/16” x 1-5/8” Lag Screws

Warning

Tag

#10 Phillips

Head

Screw

23

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com