Wayne-Dalton 9600 installation instructions Positioning Support Bracket, Installation

25	Positioning Support Bracket
Tools Needed:	NOTE: See idrive® main installation and
Power Drill	owners manual for idrive® parts.
1/8” Drill Bit	NOTE: idrive® must be installed on a
	solid mounting surface.
7/16” Socket
Driver	Locate the mounting surface. The
	mounting surface is a vertical board
	running directly above the center of the

45 angle	Antenna	mounting
	wire
		surface

door. Remove (2) 1/4”-20 flange nuts

from bottom of opener.

NOTE: Do not discard flange nuts.

Place the support bracket underneath

opener, to the right side of motor,

centered on mounting surface. Using a

tape measure, level the bottom of the

TorqueMaster® spring tube to the top of

the door section with the idrive® resting

on the support bracket. Once

TorqueMaster® spring tube is level, drill

1/8” pilot holes for the lag screws. Then

secure support bracket to the mounting

surface with (2) 1/4” x 1-1/2" lag

screws.

	1/4” X
	1-1/2” LAG
(Header)	SCREWs
	TOP OF DOOR

TorqueMaster® spring tube

SUPPORT

BRACKET

1/4” - 20

FLANGE NUTS

mounting

studs

INSTALLATION

IMPORTANT: TorqueMaster® spring

tube must be level after support

bracket is fasten to mounting

surface.

NOTE: If wood mounting surface is

behind dry wall, use 1/4” x 2” lag

screws.

Lift and slide the opener over the

support bracket, aligning the mounting

studs with the bracket slots. Loosely

fasten to mounting studs with the (2)

1/4”-20 flange nuts.

NOTE: Do not tighten 1/4”-20 flange

nuts to opener studs at this time.

Remove the temporary orange label

holding the antenna wire. Straighten

antenna wire and angle it 45 degrees to

the right.

NOTE: Do not coil the antenna wire.

This will reduce the radio signal range.

mounting

studs bracket slots

	support
TorqueMaster®	bracket
spring tube

(2) 1/4” - 20

flange nuts

“x”	“x”	“x”
	top section

Using a tape measure, maintain an equal measurement “x” (top of door to bottom of Torquemaster® tube) at both ends and the center.

25

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com