Wayne-Dalton 9600 installation instructions idrive Installation

19	idrive® Installation
Tools Needed:	NOTE: See idrive® main installation and
	owners manual for idrive® parts.
	IMPORTANT: Right and left hand
	is always determined from inside	Left Hand Side
	the garage looking out.	TorqueMaster® Spring Tube
		and Bearing profiles aligned	Motor
	With the TorqueMaster® spring tube on
	the floor (inside garage) in front of the
	door with the labeled end to the left.
	Look into the opener’s left side to	Right Hand End
	ensure the left hand bearing and the
	internal (black) sleeve are aligned with	of TorqueMaster®
		Spring Tube
	the TorqueMaster® spring tube profile.
			INSTALLATION
	IMPORTANT: Hold Opener by the
	main body. Do NOT hold by the
	Motor.
	NOTE: Opener will not slide over a
	torque tube label. Attempting to slide
	opener over the left end of the
	TorqueMaster® spring tube can damage
	the internal electronics.		Right Hand Side
	Once aligned, slide the opener onto the		TorqueMaster®
			Spring Tube and
	right hand end of the TorqueMaster®
			Bearing profiles
	spring tube. As the right end of the		aligned
	TorqueMaster® spring tube enters the
	internal (black) sleeve, rotate the
	opener back and forth slightly to help
	aid alignment.
	Continue sliding the opener onto the
	TorqueMaster® spring tube. Align the
	right hand bearing with the
	TorqueMaster® spring tube and slide
	the opener completely onto the
	TorqueMaster® spring tube until the
	TorqueMaster® spring tube exits the
	opener right hand bearing.
	NOTE: Do not force the opener onto the
	TorqueMaster® spring tube if
	misalignment occurs.
	Continue sliding the opener to the
	center of the TorqueMaster® spring
	tube.		Plug-in Motor
			Power Cord
	Plug the motor power cord into the
	opener.
			21

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com