Wayne-Dalton 9600 installation instructions TorqueMaster Spring Tube, Center Bracket Bushing

17

Tools Needed:

None

TorqueMaster® Spring Tube

TorqueMaster® springs come lubricated and pre-assembled inside the TorqueMaster® spring tube. To install, lay the TorqueMaster® spring tube on the floor (inside garage) in front of the door with the labeled end to the left.

TorqueMaster®

Spring Tube

LABELED END

18	Center Bracket Bushing		CENTER
			BRACKET
			ASSEMBLY
Tools Needed:	NOTE: If you are installing the idrive®
	opener on your garage door, skip this
	step and continue with Step 19.
	NOTE: If you are not installing the
	idrive® opener on your garage door, you	TorqueMaster	®
	must install the center bracket bushing
		Spring Tube
	assembly. Follow these instructions for
	non-idrive®operated garage doors.
	NOTE: If you are installing a
	DoorMaster™ opener, see optional		TorqueMaster®
	DoorMaster™ Bracket installations on
	page 32, Figure A.		Spring Tube
	Being cam shaped the center bracket
	bushing only fits one way.
	Slide the center bracket assembly
	towards the center of the TorqueMaster®
	spring tube, from the right side as
	shown.		CENTER
	NOTE: Upon completion of this step,		BRACKET
			BUSHING
	continue with Step 20.

20

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com