Wayne-Dalton 9600 installation instructions Side Lock, DoorMasterTM Bracket

❉

Tools Needed:

Power Drill

7/16” Socket

Driver

Side Lock

Install the side lock on the second section of the door. Secure the lock to the section with (4) 1/4”- 20 x 11/16” self drilling screws. Square the lock assembly with the door section and align with the square hole in the vertical track. The side lock should be spaced approximately 1/8” from the section edge.

IMPORTANT: side locks must be removed or made inoperative in the unlocked position if an operator is installed on the door.

NOTE: After completing this step, continue with Step 9 on page 15.

1/8”

(4)1/4”- 20 x 11/16” self drilling screws

❉	DoorMasterTM Bracket	a
		DoorMasterTM bracket/
		DRIVE GEAR ASSEMBLY
Tools Needed:	A
	NOTE: When installing a DoorMasterTM
None	operator use the center bracket and
	drive gear supplied with your operator
	(located in DoorMasterTM package).

Slide the DoorMasterTM bracket/drive gear assembly onto the TorqueMaster® spring tube, so that the drive gear/center bracket assembly are in the center of the TorqueMaster® spring tube.

	NOTE: After completing this step,	Torquemaster® tube
	continue with Step 20 on page 22.
Tools Needed:	B	b
Power Drill	To locate the center bracket, mark the
	header halfway between the flagangles
1/8” Drill Bit		CENTER
	and level the TorqueMaster® spring tube.
7/16” Socket	Drill 1/8” pilot holes into header for the	BRACKET
		bushing
Driver	lag screws. Fasten the metal bracket to	ASSEMBLY
	the header using (2) 1/4” x 1-1/2” lag
	screws.
	NOTE: After completing this step,
	continue with Step 29 on page 28.	(2) 1/4” x 1-1/2”
		hex head lag
		screws

32

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com